logo
NOTICE:  This is the new PunchCAD forum. You should have received an email with your new password around August 27, 2014. If you did not, or would like it reset, simply use the Lost Password feature, and enter Answer as the security answer.
Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error
Measurments - feet and inches
Options
Go to last post Go to first unread
Previous Topic Next Topic
Jimbl  
#1 Posted : Tuesday, February 3, 2015 10:20:50 AM(UTC)
Jimbl

Rank: Member

Joined: 11/23/2014(UTC)
Posts: 40

Thanks: 7 times
Was thanked: 2 time(s) in 2 post(s)
I am running Shark Lt 1016. When i am drawing in inches all measurements are i inches and less than an inch is in decimals which is fine. When i switch to feet/inches all measurements are in feet and inches the fraction is rounded off to 1/8" even if i am set to 1/16" in the preferences under units.Any ideas or is this a glitch?

Thanks Jim
Back to top
Guest  
#2 Posted : Tuesday, February 3, 2015 12:52:15 PM(UTC)
Guest

Rank: Guest

Joined: 8/27/2014(UTC)
Posts: 394

Was thanked: 13 time(s) in 12 post(s)
Hi Jim

Drawing pref and dimension tolerance are two separate things. Is the line when clicked on not displaying the fraction at correct tolerance or are you referring to the dimension value. If it is the dimension select the dimension open inspector and change the linear value in the tolerance tab

Regards
Jason
Back to top
Users browsing this topic
Guest (2)
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF.NET 2.1.2 | YAF.NET © 2003-2024, Yet Another Forum.NET